https://fixmycabinet.com This method works for repairing loose MDF, Thermoroil or vinyl wrap cabinet door edges. These flexible plastic cabinet door edges can be re-glued with Elmers glue. Sometimes you can fix them without taking them off of the cupboards.
Here how to fix MDF doors that are coming unglued:
Materials Needed
1) Elemers Glue All
2) Damp sponge or rag
3) Screw driver
It will be easier to make the repair if you remove the doors from the cabinets. This is why you need the screwdriver. You do not have to do this though.
You can empty the drawers and remove them to fix the edges that are coming off.
Follow these steps:
-Gently pull the vinyl edge back enough to insert the tip of the glue bottle between the board and the vinyl.
-As you apply the glue, keep pressure on the edge in order to hold it back out of the way.
-Press the edge down with your finger or a damp sponge or rag.
-Wipe the excess glue off of the door with a wet cloth or sponge.
-Wait about twenty minutes and reapply pressure to the Thermofiol cabinet door edges.
-At this point the glue is stickier than when you first applied it on wet. This will cause any remaining loose vinyl to adhere to the edge of the door.
-Wait ten to twenty four hours and lightly sand the vinyl to ensure that someone won’t catch the edge with their fingers again a peal it off.
That’s how to repair an MDF vinyl cabinet door that has loose edges. It is possible to do this procedure while the doors are still on the cabinets, but it’s hard to squirt the glue on the bottom edges of the Thermofoil base doors.
Post time: Jun-25-2017