Introduction to Pureshield
Pureshield is a fast growing company which deals with the sourcing, development, and distribution of high-end surface technology products. Pureshield Car Glass Sealant is a hydrophobic coating for Automotive Glass which enhance visibility by repelling water, dirt and oils making the glass easy to clean. Pureshield Car Glass selant is a 3 sachet set for Pre-Cleaning, Sealing and Polishing.
Preparing For Application
Car must be inside the garage and away from direct sunlight before the application .
Clean the outer glass surface to be applied thoroughly with water and make it dry
In hot conditions, when temperature is over 35 degree celcius, it is advisable to keep the temperature down by switching on the air conditioner in the car.
Wipe the glass clean with lint free cotton cloth, and ensure that all traces of water and dust are removed.
Application
Wear gloves provided in the set before starting application.
Pre-Cleaning,
Open the Cleaning Sachet(Sachet No:1), and use cleaning cloth to wipe clean the glass in uniform circular motions.
Ensure that the entire surface of the glass is wiped clean. Do not leave any gaps.
Wipe clean the glass, at least twice using both sides of the cleaning cloth.
This will help to remove any additional grease or any other oily substances which will not be cleaned with water alone.
Make sure that the Glass is completely dry before the next procedure.
Sealing
Open Sealant Sachet (Sachet No;2) and use sealing cloth to apply the sealant.
Start applying from the drivers side from top to bottom and continue this till the full Glass is coated with sealant solution. Use either side of the sealing cloth, this should be done with out wasting any time as the sealant will be lost due to evaporation. As soon as the first layer is applied start polishing the surface with the same sealing cloth. with medium pressure in circular motion again starting from the drivers side and continue to the other end of the glass.
Continue this for 8 to 10 rounds till the sealant sachet is completely dry. this is done to prevent the wastage and to use maximum number of nano particles are transferred to the glass from the sealant cloth.
Polishing
• Once polishing with the sealing cloth is over, then open the Polishing cloth(sachet no:3) and polish thoroughly in circular motion for about 10 to 15 minutes with medium pressure.
• Polishing helps to fix the nano particles to the car glass and absorbs the base from the glass , so polishing is very important step in the application of Pureshield Car Glass Sealant.
• After application the car must be inside the garage for minimum 3 -6 hours. It is advisable not to use the car for 12-24 hours to ensure maximum effect.
Maintaining the Glass
Do not use any chemicals such as de-icer to clean the glass. Use plain water only.
If the hydrophobic effect fades, clean with water and polish with lint free cotton cloth.
Hydrophobic effect fades over time, especially after first application. Repeat application within 4 to 6 months of first application will give a long lasting pureshield effect.
Post time: Jun-26-2017