Video on how to install a Mr. Gasket Super Intake Gasket on a small block Chevy. Step one: Place your new intake gaskets on the top of your cylinder heads. These are thick and do not require any sealant. Step two: Install your end rail seals. Step three: use a good amount of high temperature silicone where the intake gaskets meet with the end rail seals. Step four: Install heat riser block off plates underneath the intake gaskets before using silicone if required. Step five: Make sure your intake manifold mating surfaces are clean and install your intake manifold gently on to the gaskets. Step six: Place a small amount of high temperature silicone on the threads of your intake bolts. Step seven: Install your intake manifold bolts in the factory recommended pattern and to the factory recommend torque specifications. For additional videos on ‘how- to’ for the DIYer in you, go to www.pepboys.com.
Post time: Feb-06-2018